Portable airbrush compressor for makeup, cake cooking

FEATURES

Multifunction Airbrush: Professional dual-action gravity feed airbrush is ideal for airbrush makeup, temporary tattoos, nail art, face paint, tanning, cake decoration, and more.

Easy Operation: After repeated trials, the spray gun solves the problem of air backflow and easy screw loosening in the past, giving you a more excellent experience of use.

Premium Material: Made of brand new high quality material, sturdy and durable in use.

Save Time: Save more time than hand drawing, perfect for your painting business.

Excellent Effect: Exquisite atomization and fine lines with this airbrush.

USB Charging: Include a USB cable, give you a variety of charging methods.

In order to solve don't charge, Here are some tips for you.

1. Battery cannot be charged under low voltage.

2.Charge in time when the battery is still some electric. Don't wait to until the battery is run out.

3. Don‘t use airbrush kit while charging

How to Spray:

Step 1: Install the liquid cup on the spray gun and install the spray gun on the air pump.

Step 2: Dilute the liquid properly and pour into the cup.

Step 3: Short press the ON / OFF switch on the compressor. The spray gun will now capture air fluid.

Step 4: Align the area to be sprayed with a distance of 2-3cm, move the trigger slightly backward, spray the atomized paint, and then move the spray gun back and forth.

Step 5: Clean the airbrush after use.

USB Recharge Freely:

The airbrush kit can be used anywhere after a singel charge.

Built-in 1600mAh battery, support continuously work 90 Minute with 1 hour full charge.

FAQ

1.Question: Water trap doesn't hold air anymore, what gives?

Answer: Not exactly sure what you mean by “doesn’t hold air” so I will assume you mean that the bowl leaks air whenever air pressure is applied to the inlet. The unit I have purchased has worked flawlessly but previous units I have used have occasionally developed leaks. In general there could be four reasons fir this. [1] The plastic bowl could be broken & would need to be replaced. [2] the bowl is loose & needs to be hand tightened by gripping it with your fingers & turning it clockwise into the base. [3] The bowl O-ring is missing, damaged or out of position. Unscrew the bowl & remove it from the base. An O-ring should come out with it. Make sure it is not cut or damaged. Carefully place it on the rim of the bowl & replace the bowl & ring together in the base. A tiny dab of Vaseline on the O.ring will help it seat properly. Finally [4], dirt can get into the seat of the spring loaded drain valve on the bottom of the bowl. Push the pin a few times with the valve with full air pressure applied to clear any dirt that might be keeping the valve from seating. Hope this helps.

2.Question: What is the maximum inlet pressure?

Answer: I found that the best psi is between 30 to 35 psi and that’s for me. It may range depending on what your doing and type of airbrush. But you do not want to exceed over 45 psi

3.Question: The answers for maximum inlet side pressure is unclear. i have a 200 psi compressor, will this regulate safely reduce 200 psi to 20-40 psi?

Answer: 200 psi geez that's a lot. You might run a bigger more heavy duty reg first down to 60-70 psi if your compressor doesnt have one on it. Its kinda how i have my setup for airbrushing. This one is bolted to my table next to me.

Hot Tags: cordless airbrush compressor for model painting（ac16c）, China, suppliers, manufacturers, factory