Swivel Head Pin Vise Craft Hobby Jewelers Tool, Modeler's tool Precision Pin Vise HD412

Reconstruction of various plastic models, modify, etc., and precise machining operation USE

0.1mm to 3.2mm drill bit may be used (Drill bit not included)

After use, Keep out of reach of children.

Using a drill, Excessive force can cause injury. Please be careful.

Material : metal

FAQ

1.Question:

How to store the products?

Answer:

I use Saran Wrap pushed down on the leftover product before putting the lids on the containers. I then store them in a cabinet in the garage that is heated. The two part mix is quite stable and lasts at least a couple years.

2.Question:

Can this product be bent to fit curved nosurfaces after it is moulded in a silicone mold?

Answer:

Yes, the material is very playable and would comply with a silicone mold. If your plan is to place a ball into a mold and press the material into shape of the mold and allow for excess material to flow through a gate that would work.

However if your plan to to place small amounts of material at incremental times it might be a challenge since the material was designed to adhere to wood not silicone.

In some cases I have used 0.02" aluminum sheet as a form and pressed the material into a void with the aluminum used as a material stop.

Once the material has dried I have separated the aluminum from the material.

For texture after the material has stated to set have pressed a rough sawn wood sample into the material to leave a texture,

In "some" cases once you pull even amounts of Part's A and B and mix the material is sometimes sticky.

The "stickiness" can be decreased prior to application if you allow it to air dry "temperature dependent" for a few 5-10 minutes - again "temperature dependent" (higher the ambient temperature the faster the material sets).

So yes the material can be molded using a silicone mold.

Hot Tags: pin vise craft hobby jewelers tool（hd-412）, China, suppliers, manufacturers, factory