Airbrush quick disconnect coupler release fitting Adapter, 1/8" M-F AB-117

Airbrush Quick Disconnect Coupler

with 1/8" male and female fittings

You can change the airbrushes quickly when you use multiple airbrushes with one air hose.

Airbrush 1/8" Quick Release Disconnect Coupling Adjustment valve Adaptor 2 IN 1 Fittings Part AB120

1. New and high quality

2. You can adjust the working pressure by adjusting the knob on it.

3. You can disconnect airbrush from air hose quickly

4. Airbrush connecter with 1/8" male and female fittings, suitable for most of airbrushes and air hose.

Introductions:

If you are looking for a durable quick disconnect adaptor for your airbrush, then this Quick Release Coupling Adaptor will be your best choice. It is made of high quality material, durable in use. It is easy for you to disconnect airbrush from air hose in just a second.

FAQ

1.Question: Water trap doesn't hold air anymore, what gives?

Answer: Not exactly sure what you mean by “doesn’t hold air” so I will assume you mean that the bowl leaks air whenever air pressure is applied to the inlet. The unit I have purchased has worked flawlessly but previous units I have used have occasionally developed leaks. In general there could be four reasons fir this. [1] The plastic bowl could be broken & would need to be replaced. [2] the bowl is loose & needs to be hand tightened by gripping it with your fingers & turning it clockwise into the base. [3] The bowl O-ring is missing, damaged or out of position. Unscrew the bowl & remove it from the base. An O-ring should come out with it. Make sure it is not cut or damaged. Carefully place it on the rim of the bowl & replace the bowl & ring together in the base. A tiny dab of Vaseline on the O.ring will help it seat properly. Finally [4], dirt can get into the seat of the spring loaded drain valve on the bottom of the bowl. Push the pin a few times with the valve with full air pressure applied to clear any dirt that might be keeping the valve from seating. Hope this helps.

2.Question: What is the maximum inlet pressure?

Answer: I found that the best psi is between 30 to 35 psi and that’s for me. It may range depending on what your doing and type of airbrush. But you do not want to exceed over 45 psi

3.Question: The answers for maximum inlet side pressure is unclear. i have a 200 psi compressor, will this regulate safely reduce 200 psi to 20-40 psi?

Answer: 200 psi geez that's a lot. You might run a bigger more heavy duty reg first down to 60-70 psi if your compressor doesnt have one on it. Its kinda how i have my setup for airbrushing. This one is bolted to my table next to me.

Hot Tags: airbrush quick disconnect coupler release fitting for iwata airbrush（ab-117/ab-120/ab-117m）, China, suppliers, manufacturers, factory